Glycine leaching of Sarcheshmeh chalcopyrite concentrate at high pulp densities in a stirred tank reactor

No Thumbnail Available
Journal Title
Journal ISSN
Volume Title
A1 Alkuperäisartikkeli tieteellisessä aikakauslehdessä
This publication is imported from Aalto University research portal.
View publication in the Research portal
View/Open full text file from the Research portal
Date
2020-10-01
Major/Subject
Mcode
Degree programme
Language
en
Pages
10
Series
Minerals Engineering, Volume 157
Abstract
The simplest amino acid, glycine has recently been reported as a safe and environmentally benign reagent for the extraction of copper from both oxide and sulfide minerals. In the current study, leaching of a chalcopyrite concentrate from the Sarcheshmeh Copper Mine (Kerman, Iran) was conducted in stirred tank reactors in the presence of a glycine medium. The effect of some critical leaching parameters including glycine concentration (0.4–2 M), temperature (30–90 °C), stirring rate (250–750 rpm), pH (9–12), oxygen flowrate (0.5–2 L/min) and pulp density (1–20%) was investigated on copper recovery from the chalcopyrite concentrate. Results show that an increase in temperature from 30 to 60 ˚C enhanced the copper extraction, whereas at conditions > 60 ˚C a decrease in copper extraction was observed, probably as a result of the conversion of glycine to glycinate and decrease in oxygen solubility. Moreover, prolonged leaching times at higher pH levels (10.5 and 12) led to a decrease in the extraction of copper, primarily due to the chemical precipitation of copper sulfide and crystallization of copper glycinate. By increasing the pulp density from 1 to 20%, copper extraction declined significantly primarily as a consequence of the partial dissolved copper precipitation at higher copper concentrations. SEM/WDX analyses were subsequently used in order to evaluate the leach residues. Further investigation determined that the activation energy of the glycine leaching of concentrate was 37.4 KJ/mol, thus the kinetics were controlled by diffusion of the reagents through the product layer. From these results, it is evident that due to the high initial rate of glycine leaching and the precipitation of copper-bearing phases (i.e. copper glycinate and covellite) at high pulp densities, glycine leaching processes are recommended for the treatment of low grade chalcopyrite concentrates, ores or tailings.
Description
Keywords
Glycine, Leaching, Kinetics, Chalcopyrite concentrate
Other note
Citation
Khezri Khabisi , M , Rezai , B , Abdollahzdeh , A A , Molaeinasab , M , Wilson , B P & Lundström , M 2020 , ' Glycine leaching of Sarcheshmeh chalcopyrite concentrate at high pulp densities in a stirred tank reactor ' , Minerals Engineering , vol. 157 , 106555 . https://doi.org/10.1016/j.mineng.2020.106555