A study about signal variation with minor receiver displacement in a meeting room at 60 GHz: measurements and simulations

Loading...
Thumbnail Image

Access rights

openAccess

URL

Journal Title

Journal ISSN

Volume Title

A1 Alkuperäisartikkeli tieteellisessä aikakauslehdessä

Date

2021-12

Major/Subject

Mcode

Degree programme

Language

en

Pages

Series

EURASIP Journal on Wireless Communications and Networking, Volume 2021, issue 1

Abstract

The aim of this work is to study the impact of small receiver displacement on a signal propagation in a typical conference room environment at a millimeter wave frequency of 60 GHz. While channel measurements provide insights on the propagation phenomena, their use for the wireless system performance evaluation is challenging. Whereas, carefully executed three-dimensional ray tracing (RT) simulations represent a more flexible option. Nevertheless, a careful validation of simulation methodology is needed. The first target of this article is to highlight the benefits of an in-house built three-dimensional RT tool at 60 GHz and shows the effectiveness of simulations in predicting different characteristics of the channel. To validate the simulation results against the measurements, two different transmitter (Tx) positions and antenna types along with ten receiver (Rx) positions are considered in a typical conference room. In first system configuration, an omnidirectional antenna is placed in the middle of the table, while in the second system configuration a directed horn antenna is located in the corner of the meeting room. After validating the simulation results with the measurement data, in the second part of this work, the impact of a small change, i.e., 20 cm in the receiver position, is studied. To characterize the impact, we apply as performance indicators the received power level, root mean square delay spread (RMS-DS) and RMS angular spread (RMS-AS) in azimuth plane. The channel characteristics are considered with respect to the direct orientation (DO), i.e., the Rx antenna is directed toward the strongest incoming path. Different antenna configurations at the Tx and Rx side are applied to highlight the role of antenna properties on the considered channel characteristics. Especially, in the second system configuration the impact of different antenna half power beamwidth on different considered channel characteristics is highlighted through acquired simulation results. The validation of results shows the RMS error of only 2–3 dB between the measured and simulated received power levels for different Tx configurations in the direction of DO. Results indicate that only a small change of the Rx position may result a large difference in the received power level even in the presence of line-of-sight between the Tx and Rx. It is found that the STD of received power level across the room increases with the decrease in HPBW of the antenna. As can be expected, directed antennas offer lower value of RMS-DS and RMS-AS compared with isotropic antenna.

Description

Funding Information: This work was partly supported by the Finnish public funding agency for research, Business Finland under the project “5G Finnish Open Research Collaboration Ecosystem (5G-FORCE)” which is part of 5G Test Network Finland. Publisher Copyright: © 2021, The Author(s). Copyright: Copyright 2021 Elsevier B.V., All rights reserved.

Keywords

60 GHz, Angular spread, Channel characterization, Delay spread, Indoor radio channel, Measurements, Ray tracing, Simulations

Other note

Citation

Sheikh, M U, Ruttik, K, Jäntti, R & Hämäläinen, J 2021, ' A study about signal variation with minor receiver displacement in a meeting room at 60 GHz: measurements and simulations ', Eurasip Journal on Wireless Communications and Networking, vol. 2021, no. 1, 81 . https://doi.org/10.1186/s13638-021-01965-9