Rakennusvaiheen vaikutus kerrostalon massiivipuulevyliitosten rakennusfysikaaliseen toimivuuteen

Loading...
Thumbnail Image

URL

Journal Title

Journal ISSN

Volume Title

Insinööritieteiden korkeakoulu | Master's thesis

Date

2023-06-12

Department

Major/Subject

Mcode

Degree programme

Master's Programme in Building Technology (CIV)

Language

fi

Pages

90 + 43

Series

Abstract

Tutkimuksessa tarkasteltiin massiivipuulevyrunkoisen (CLT) 5-kerroksisen kerrostalon ulkoseinän ja välipohjan liittymien rakennusfysikaalista toimivuutta rakentamisvaiheessa tapaustutkimuskohteen ja laskentatarkastelujen avulla. Tarkasteltava kohde rakennettiin ilman erillisrunkoista sääsuojaa. Ulkoseinän ja välipohjan liittymien kosteuspitoisuutta mitattiin kahdessa kohtaa rakennusta. Tehtyjen mittausten perusteella rakenneliittymät ja rakenteet ovat pääasiassa kuivia runkovaiheen jälkeen runkovaiheen aikana tapahtuneesta sadevesirasituksesta huolimatta. Mittaustulosten arvoilla tarkasteltiin homeen kasvun mahdollisuutta Suomalaisella homemallilla. Yhden mittauspisteen kohdalla ei homeen kasvun mahdollisuutta rakennusvaiheen aikana voitu sulkea pois. Mittausten lopettamisen jälkeistä, rakennuksen käytön aikaista mittauspisteiden kuivumista ja homeen kasvun kehittymistä tarkasteltiin laskennallisesti kolmen vuoden ajanjaksolla. Tarkastelun perusteella homeen kasvun määrä ei lisäänny merkittävästi mittausten lopettamisen jälkeisen tarkastelujakson aikana. Laskennallisen kuivumistarkastelun perusteella rakennusvaiheessa kastunut liittymä kuivuu hitaammin kuin kastuneen CLT-betoni liittovälipohjan betonin ja puun rajapinta. Mittaus- ja laskentatuloksia verrattaessa huomattiin, että ennen kastumista kosteussulkuaineella pintakäsitellyn CLT-laatan kastuessa sateen vaikutuksesta ennen betonilaatan valua, saavutetaan CLT-laatan pintalamellissa korkeita kosteuspitoisuuksia. Ulkoseinän ja välipohjan liittymässä sijaitsevien vedenpoistourien tiivistyksen tarvetta tarkasteltiin rakennuksen käytön aikaisen kosteuden kondensoitumisen näkökulmasta. Laskentatarkastelun perusteella kondensoitumisen ja homeen kasvun riski liittymässä on riippuvainen sisäilman kosteuslisän määrästä. Käytettäessä kosteuslisän arvoina kosteusluokkien 2 ja 3 mukaisia arvoja sekä tuoreisiin tutkimustuloksiin perustuvia arvoja, kolmellatoista kahdestakymmenestä simuloinnista ylitettiin homeindeksin arvo 1 viiden vuoden laskentajakson viimeisenä kalenterivuotena.

In this thesis, the hygrothermal performance during the construction phase of cross laminated timber joints of a building envelope and floor slab of a 5-story building was examined. The research was conducted as a case study including experimental and numerical parts. The construction phase of the building was carried out without a separate frame weather protection. The moisture content of the joint of the building envelope and floor slab was measured at two locations. Based on the measurements, the structural joints and structures were mainly dry after the frame erection phase, despite the rainwater encumbrance which occurred during the construction phase. Using the measurement results, the possibility of mold growth was examined using the Finnish mold growth model. At one measurement point, the possibility of mold growth during the construction phase could not be ruled out. The drying of the structures after the end of the measurements, and the development of mold growth were examined numerically over a period of three years. Based on the calculations, the amount of mold growth at the inspection points did not increase after the measurements were finished. ' Based on the calculations, The drying time of the joint is longer than the drying time of the CLT - concrete interface, if the joint gets wet. A comparison between the measured and calculated values revealed that if the CLT-slab becomes wet due to rainfall before the concrete is cast, high moisture levels are reached in the CLT-slab, even though its surface has been treated with a surface treatment agent before rainfall. The need to seal the drainage channels located at the joint of the building envelope and floor slab was examined in terms of moisture condensation during the use of the building. Based on the calculations, the risk of condensation and the subsequent growth of mold at the joint strongly depends on the humidity of the indoor air. If values given for the humidity classes 2 and 3 or values based on the recent research results were used as the humidity supplement of indoor air, in thirteen out of twenty simulations the mold index was more than one during the last calendar year of the five-year simulation.

Description

Supervisor

Puttonen, Jari

Thesis advisor

Päkkilä, Taneli
Wirtanen, Leif

Keywords

rakennusvaihe, rakennusfysiikka, kosteudenhallinta, homeen kasvu

Other note

Citation