Productivity analysis of Fuyu oil shale in-situ pyrolysis by injecting hot nitrogen
Loading...
Access rights
openAccess
publishedVersion
URL
Journal Title
Journal ISSN
Volume Title
A1 Alkuperäisartikkeli tieteellisessä aikakauslehdessä
This publication is imported from Aalto University research portal.
View publication in the Research portal (opens in new window)
View/Open full text file from the Research portal (opens in new window)
Other link related to publication (opens in new window)
View publication in the Research portal (opens in new window)
View/Open full text file from the Research portal (opens in new window)
Other link related to publication (opens in new window)
Authors
Date
2021-08-02
Department
Major/Subject
Mcode
Degree programme
Language
en
Pages
16
Series
Energies, Volume 14, issue 16
Abstract
In this paper, the effect of heat injection on productivity of Fuyu oil shale during in-situ pyrolysis was studied by using heat flow coupling analysis method. It is found that fluid conducts heat transmission to the oil shale stratum mainly along the fissure formed by hydraulic fracturing. With the increase of heating time, the oil shale on both sides of fissures were effectively pyrolyzed, and the porosity of the formation increases and the diffusion range of the nitrogen to the oil shale stratum is also improved. After 200 days, the oil shale around the fractures first reaches the pyrolysis temperature, and 700 days later, the average temperature of the oil shale stratum reaches 500◦C; therefore, the whole oil shale can be effectively pyrolyzed. Productivity analysis shows that the best exploitation temperature is 500◦C. When the gas injection rate is in the range of 1.0~11.0 m3/min, different degrees of heat loss will occur, and the output is also different. The pyrolysis time reaches 100~150 days, showing the peak value of daily production, which is between 0.5~3.2 m3/day. The pressure of displacement fluid affects oil shale product recovery in in-situ pyrolysis. High pressure helps to improve the displacement efficiency of oil and gas products and increase the productivity of oil shale in-situ pyrolysis. The best acting pressure is 9.5 MPa.Description
Funding Information: Acknowledgments: In the course of this experiment, it was supported by the pilot experimental base for in-situ pyrolysis of Fuyu oil shale, Jilin University. The authors also express their appreciation to technical reviewers for their constructive comments. Funding Information: Funding: This research was funded by “the Fundamental Research Funds for the Central Universities, grant number 2021QN1002” and “China Postdoctoral Science Foundation, grant number 2021M693421” and the National Natural Science Foundation of China (Grant No. 41972324). Publisher Copyright: © 2021 by the authors. Licensee MDPI, Basel, Switzerland.
Keywords
In-situ pyrolysis, Numerical simulation, Oil shale, Productivity analysis, Thermal fluid pressure coupling
Other note
Citation
Zhao, S, Li, Q, Lü, X & Sun, Y 2021, ' Productivity analysis of Fuyu oil shale in-situ pyrolysis by injecting hot nitrogen ', Energies, vol. 14, no. 16, 5114 . https://doi.org/10.3390/en14165114