Laser-probe analysis of modern electroacoustic microwave devices

 |  Login

Show simple item record

dc.contributor Aalto-yliopisto fi
dc.contributor Aalto University en Holmgren, Olli 2012-08-23T07:21:28Z 2012-08-23T07:21:28Z 2009
dc.identifier.isbn 978-952-248-051-4
dc.identifier.isbn 978-952-248-050-7 (printed) #8195;
dc.identifier.issn 1795-4584
dc.description.abstract In this thesis, devices based on surface acoustic waves (SAWs) and microelectromechanical systems (MEMS) are investigated using laser-probe measurements. The type of SAW and MEMS devices studied here are typically used, for example, in mobile phones as radio frequency components, such as filters and reference oscillators. The dissertation focuses on measuring and analyzing vibration fields in the devices using the scanning Michelson laser interferometer developed at TKK. The interferometer as such detects out-of-plane vibrations, i.e., vibrations perpendicular to the surface of the device, with minimum detectable vibration amplitude reaching down to 0.3 pm for a detection bandwidth of 1 kHz. The spatial resolution in the scanning plane of the interferometer is better than 1 µm and the detectable vibration frequencies range from 1 MHz to 2.5 GHz. In the thesis, a novel detection method to measure also in-plane vibrations is presented and applied to the analysis of a square-plate MEMS resonator. In the first part of the thesis, operation of novel SAW devices, such as a longitudinal leaky SAW (LLSAW) resonator, a double resonance filter and a piston-mode filter with transverse mode suppression are thoroughly analyzed by combining the interferometric measurement results with numerical simulations and data from electrical measurements. The measurements of the vibration fields in the LLSAW resonator reveal side radiation of Rayleigh waves, which constitutes an acoustic loss mechanism for the resonator. The analysis of the piston-mode filter indicates that one of the parameters for the transverse mode suppression has been underestimated in the filter design. In the second part of the thesis, vibration modes in a square-plate MEMS resonator are analyzed. Comparing the laser-probe measurements with simulations, it can be concluded that the main in-plane vibration mode is companioned by a parasitic out-of-plane mode, that may affect the quality factor of the main mode. The laser-probe measurements enable studying directly the vibrations in SAW and MEMS devices and hence provide new information on the physics and operation of these devices, not obtainable from the electrical measurements or simulations alone. The measurements provide support for the development of new SAW and MEMS components satisfying stringent specifications. en
dc.format.extent Verkkokirja (6630 KB, 60 s.)
dc.format.mimetype application/pdf
dc.language.iso en en
dc.publisher Teknillinen korkeakoulu en
dc.relation.ispartofseries TKK dissertations, 178 en
dc.relation.haspart [Publication 1]: O. Holmgren, J. V. Knuuttila, T. Makkonen, K. Kokkonen, V. P. Plessky, W. Steichen, M. Solal, and M. M. Salomaa. 2005. Imaging surface-acoustic fields in a longitudinal leaky wave resonator. Applied Physics Letters, volume 86, number 2, 024101. © 2005 American Institute of Physics. By permission. en
dc.relation.haspart [Publication 2]: Olli Holmgren, Tapani Makkonen, Jouni V. Knuuttila, Mikko Kalo, Victor P. Plessky, and William Steichen. 2007. Side radiation of Rayleigh waves from synchronous SAW resonators. IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, volume 54, number 4, pages 861-869. © 2007 IEEE. By permission. en
dc.relation.haspart [Publication 3]: Johanna Meltaus, Seong Su Hong, Olli Holmgren, Kimmo Kokkonen, and Victor P. Plessky. 2007. Double-resonance SAW filters. IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, volume 54, number 3, pages 659-667. © 2007 IEEE. By permission. en
dc.relation.haspart [Publication 4]: Marc Solal, Olli Holmgren, and Kimmo Kokkonen. Design, simulation and visualization of R-SPUDT devices with transverse mode suppression. IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, accepted for publication. © 2009 IEEE. By permission. en
dc.relation.haspart [Publication 5]: O. Holmgren, K. Kokkonen, T. Mattila, V. Kaajakari, A. Oja, J. Kiihamäki, J. V. Knuuttila, and M. M. Salomaa. 2005. Imaging of in- and out-of-plane vibrations in micromechanical resonator. Electronics Letters, volume 41, number 3, pages 16-17. © 2005 The Institution of Engineering and Technology (IET). By permission. en
dc.relation.haspart [Publication 6]: Olli Holmgren, Kimmo Kokkonen, Timo Veijola, Tomi Mattila, Ville Kaajakari, Aarne Oja, Jouni V. Knuuttila, and Matti Kaivola. 2009. Analysis of vibration modes in a micromechanical square-plate resonator. Journal of Micromechanics and Microengineering, volume 19, number 1, 015028. © 2009 Institute of Physics Publishing. By permission. en
dc.subject.other Electrical engineering
dc.subject.other Physics
dc.title Laser-probe analysis of modern electroacoustic microwave devices en
dc.type G5 Artikkeliväitöskirja fi
dc.contributor.department Teknillisen fysiikan laitos fi
dc.subject.keyword laser interferometry en
dc.subject.keyword surface acoustic wave en
dc.subject.keyword microelectromechanical system en
dc.subject.keyword resonator en
dc.subject.keyword filter en
dc.identifier.urn URN:ISBN:978-952-248-051-4
dc.type.dcmitype text en
dc.type.ontasot Väitöskirja (artikkeli) fi
dc.type.ontasot Doctoral dissertation (article-based) en

Files in this item

This item appears in the following Collection(s)

Show simple item record

Search archive

Advanced Search

article-iconSubmit a publication