Synthesis of solid NMC622 particles by spray drying, post-annealing and lithiation

Abstract

Layered lithium-nickel-manganese-cobalt oxide (NMC) cathode materials are widely used in Li-ion batteries that require high energy densities, such as those used in plug-in hybrid electric vehicles (PHEVs) and electric vehicles (EVs). Here we studied the synthesis of NMC622 particles by spray pyrolysis, which is a simple one-step process for production of spherical particles. However, synthesising NMC powder using spray pyrolysis has a tendency to produce hollow NMC particles. To gain insight into the mechanism behind the formation of the hollow particles, one dimensional numerical simulation of the physical and chemical phenomena taking place during spray drying were carried out. The effects of several process parameters, including drying air temperature, drying air mass flow rate, and liquid feed mass flow rate, on the evaporation and particle formation process were studied. The increased evaporation rate at higher temperatures was found to result in crust formation on the droplet surface during the particleformation, and thus, in lower solid volume fractions in the dried particles. However, by optimizing the process parameters production of solid NMC622 sulphate particles by spray drying was achieved. The produced NMC622 sulphate particles were then oxidised and lithiated in air at 850 °C via the conventional thermal treatment process. Four lithium precursors, LiOH, Li2CO3, Li2SO4 and LiNO3, were tested for the lithiation of the oxidized NMC particles. The degree of lithiation and the crystalline phase of the powders were determined using ICP-OES and XRD, respectively.