Browsing by Author "Pärssinen, Aarno"
Now showing 1 - 12 of 12
Results Per Page
Sort Options
Item A 20-60GHz Digitally Controlled Composite Oscillator for 5G(2018) Antonov, Yury; Tormanen, Markus; Ryynänen, Jussi; Pärssinen, Aarno; Stadius, Kari; Department of Electronics and Nanoengineering; Jussi Ryynänen Group; Lund University; University of OuluThis paper describes a frequency generator supporting over-an-octave tuning range for 5G receiver front-end. Generator is built by composition of smaller-range oscillators multiplexed to the common output that drives a downconversion mixer. Simulated in 28nm CMOS with full physical device models the composite oscillator exhibits a frequency tuning range from 21.5 to 60.7GHz (95.3%) dissipating less then 25.8mW from a 0.9V supply. As a result, it achieves −184dBc/Hz FOM TR.Item A 5.4-GHz 2/3/4-modulus fractional frequency divider circuit in 28-nm CMOS(2021) Cheung, Tze Hin; Ryynänen, Jussi; Pärssinen, Aarno; Stadius, Kari; Department of Electronics and Nanoengineering; Jussi Ryynänen Group; University of OuluThis paper describes the design and post-layout simulations of a 2/3/4- modulus frequency divider circuit, accompanied with an accumulator that controls the division count. The circuit is capable of operating as an integer or as a fractional divider. Key topic of this paper is the merging of div-2/3 and div-3/4 circuits into a single compact circuit that solves an issue of a forbidden state in fractional-division operation. The circuit is designed with 28-nm CMOS technology and the post-layout simulations indicate an operating input frequency range of 0.3 - 5.4 GHz with 13-bit fractional frequency resolution between division ratios of 2-4. The divider occupies only 40 µm x 30 µm while consuming 2.0 mW at 5.4 GHz input frequency.Item Active BiCMOS mixers for direct downconversion(2001) Kivekäs, Kalle; Pärssinen, Aarno; Sähkö- ja tietoliikennetekniikan osasto; Teknillinen korkeakoulu; Helsinki University of Technology; Halonen, KariItem A configurable sampling rate converter for all-digital 4G transmitters(2013) Roverato, Enrico; Kosunen, Marko; Lemberg, Jerry; Nieminen, Tero; Stadius, Kari; Ryynänen, Jussi; Eloranta, Petri; Kaunisto, Risto; Pärssinen, Aarno; Department of Micro and Nanosciences; Jussi Ryynänen GroupItem Design and Implementation of the Control Software for a Radio Frequency Modem(2006) Raiskila, Kalle; Pärssinen, Aarno; Sähkö- ja tietoliikennetekniikan osasto; Teknillinen korkeakoulu; Helsinki University of Technology; Saikkonen, HeikkiItem Fast Sampling Downconverter for Low-Cost Digital Receiver(1995) Pärssinen, Aarno; Long, Stephen; Sähkötekniikan osasto; Teknillinen korkeakoulu; Helsinki University of Technology; Porra, VeikkoItem Integrated mixers for direct conversion receivers(1999) Kivekäs, Kalle; Pärssinen, Aarno; Sähkö- ja tietoliikennetekniikan osasto; Teknillinen korkeakoulu; Helsinki University of Technology; Halonen, KariTässä diplomityössä tutkittiin erilaisten sekoittajien soveltuvuutta integroituihin suoramuunnosvastaanottimiin. Suoramuunnossekoittajien suunnittelun keskeisimmät ongelmat liittyvät matalataajuisiin häiriöihin, jotka haittaavat halutun signaalin ilmaisua. Työn tulosten perusteella korkealaatuinen suoramuunnossekoittaja voidaan toteuttaa ja sillä voidaan saavuttaa hyvä toisen kertaluvun lineaarisuus huolellisella piirisuunnittelulla ilman kompensointia. Aluksi työssä käsiteltiin sekoittajien yleistä teoriaa. Seuraavaksi tutkittiin suoramuunnossekoittajien erityisvaatimuksia. Paikallisoskillaattorisignaalin ominaisuuksia ja sekoittajan rajapintoja LNAn ja kantataajuusosien kanssa pohdittiin lyhyesti. Työssä suunniteltiin ja mitattiin viisi 25 GHz:n ja 0,35 µm:n BiCMOS-teknologialle toteutettua sekoittajaa, joista neljä on piiritopologialtaan erilaisia ja yksi toteutettu kvadratuurisekoittajana. Kaikki sekoittajat ovat muunnoksia Gilbertin kertojasolusta. Yksi sekoittajista on bipolaarinen ja lopuissa on käytetty MOS-tekniikkaa soveltuvin osin. Yhdessä BiCMOS sekoittajista on aktiivinen kuorma ja sille on toteutettu digitaalinen vahvistuksen säätö. Toteutettujen sekoittajien lisäksi passiivisen CMOS-kertojan toimintaa analysoitiin ja sen soveltuvuutta suoramuunnosarkkitehtuuriin tarkasteltiin. Mittaustulokset vastasivat varsin hyvin simulointeja ja tukivat teoreettisia tuloksia.Item Low Noise Amplifiers for Direct Conversion Multi-Band Receivers(2001) Ryynänen, Jussi; Pärssinen, Aarno; Sähkö- ja tietoliikennetekniikan osasto; Teknillinen korkeakoulu; Helsinki University of Technology; Halonen, KariItem Radio Frequency Front-End for a Global Positioning System Receiver(2001) Sivonen, Pete; Pärssinen, Aarno; Sähkö- ja tietoliikennetekniikan osasto; Teknillinen korkeakoulu; Helsinki University of Technology; Halonen, KariItem Subharmonically Sampling Mixers for RF Signal Downconversion(1997) Pärssinen, Aarno; Long, Stephen; Sähkö- ja tietoliikennetekniikan osasto; Teknillinen korkeakoulu; Helsinki University of Technology; Porra, VeikkoItem Towards versatile access networks(2023-06-06) Ghoraishi, Mir; Alexiou, Angeliki; Cogalan, Tezcan; Conrat, Jean Marc; De Guzman, Mar Francis; Devoti, Francesco; Eappen, Geoffrey; Fang, Chao; Frenger, Pål; Girycki, Adam; Guo, Hao; Halbauer, Hardy; Haliloglu, Omer; Haneda, Katsuyuki; Koffman, Israel; Kyösti, Pekka; Leinonen, Marko; Li, Yinggang; Madapatha, Charitha; Makki, Behrooz; Navarro-Ortiz, Jorge; Nguyen, Le Hang; Nimr, Ahmad; Pärssinen, Aarno; Pollin, Sofie; Pryor, Simon; Puerta, Rafael; Rahman, Md Arifur; Ramos-Munoz, Juan J.; Ranjbar, Vida; Roth, Kilian; Sarajlic, Muris; Sciancalepore, Vincenzo; Svensson, Tommy; Tervo, Nuutti; Wolfgang, Andreas; Gigasys Solutions; University of Piraeus; Samsung; Orange; Department of Electronics and Nanoengineering; NEC Corporation; Brunel University London; Chalmers University of Technology; Ericsson AB; IS-Wireless; Nokia Solutions and Networks GmbH & Co. KG; RunEL; University of Oulu; Instituto Carlos I de Física Teórica y Computacional; Technische Universität Dresden; KU Leuven; Acceleran; University of Granada; Intel; Qamcom Research and Technology AB; Bulakçı, Ömer; Li, Xi; Gramaglia, Marco; Gavras, Anastasius; Uusitalo, Mikko; Rugeland, Patrik; Boldi, MauroCompared to its previous generations, the 5th generation (5G) cellular network features an additional type of densification, i.e., a large number of active antennas per access point (AP) can be deployed. This technique is known as massive multipleinput multiple-output (mMIMO) [1]. Meanwhile, multiple-input multiple-output (MIMO) evolution, e.g., in channel state information (CSI) enhancement, and also on the study of a larger number of orthogonal demodulation reference signal (DMRS) ports for MU-MIMO, was one of the Release 18 of 3rd generation partnership project (3GPP Rel-18) work item. This release (3GPP Rel-18) package approval, in the fourth quarter of 2021, marked the start of the 5G Advanced evolution in 3GPP. The other items in 3GPP Rel-18 are to study and add functionality in the areas of network energy savings, coverage, mobility support, multicast broadcast services, and positioning.Item A Wideband IF Receiver Module for Flexibly Scalable mmWave Beamforming Combining and Interference Cancellation(2019) Akbar, Rehman; Klumperink, Eric A. M.; Tervo, Nuutti; Javed, M. Y.; Stadius, Kari; Rahkonen, Timo; Pärssinen, Aarno; Department of Electronics and Nanoengineering; Jussi Ryynänen Group; University of Oulu; University of TwenteLarge-scale phased arrays need to combine weighted signals from multiple sub-arrays either in analog or in digital domain. Sub-arrays are preferably implemented modularly with integrated circuits placed next to the associated antennas. In order to enable flexible and scalable combining networks of several mmWave sub-arrays, this paper presents a wideband receiver module that provides the cartesian combining of beamforming weights for one sub-array at IF. Furthermore, it allows interference cancellation between sub-arrays or combining multiple sub-arrays. It also provides filtering before ADCs to support current and foreseeable 5G channel bandwidths up to 800MHz. The receiver is operating at 2-4GHz IF frequency range and has more than 400MHz baseband bandwidth, a noise-figure of 5.5dB, -6dBm 1dB compression point and +3dBm in-band IIP3. In addition, over-the-air measurements are performed, showing 26dB of interference cancellation between the sub-arrays. The prototype is implemented using 45nm CMOS PDSOI.